2-35
1
2
Basic Operations
4
5
6
Printing Data
Starting a Printing Operation
1
Setting a Media ( P.2-6)
2
Checking the Heater Temperature
• Check the CONSTANT lamp lights in [PRE], [PRINT], and
[POST] below the display.
3
Press the key in LOCAL.
• The screen changes to REMOTE, and data can be received from
the PC.
4
Transmit data to be printed from the PC.
• The ACTIVE lamp blinks and the printing conditions are
displayed.
• For the method of data transmission, see the instruction
manual for the output software.
5
Start printing.
• The printing speed may change, depending on the width of
the set medium or the position of the print origin even when
the same data is printed. This is because of a difference in
resolution.
• When using a roll media, rewind the media by hand before printing so that it is not loose.When the roll
media has not been rewound tightly, it may cause the image quality to deteriorate.
To Next Page
Loading...
