3-8
Changing the Set Values of the Heaters
The optimal values of the heater setting differ depending on the ink type to be used. For details, refer to P.7-4
“Rough standard of heater temperature setting value”.
Changing the Temperature Settings for the Heaters
Here, each item of "SET TEMP." and "SET TIME" is set.
1
Press the key in LOCAL.
2
Press the key.
3
Press to selectone of the user types (1 to 4).
4
Press the key.
5
Press the key to select "HEATER".
6
Press the key twice.
• The heater temperature setting screen appears.
SET TEMP
Used to change the set temperature of the pre-heater, print heater, and
post-heater inside the platen.
SET TIME
STANDBY
Used to set the time it takes until the temperature of the heaters falls to
reach the preheat temperature after printing has been complete.
Set Value:NONE, 0 to 90 min (by the unit of 10 min)
• The preheat temperature has been preset and cannot be changed.
• If the machine receives data with the preheat temperature reached, the
heaters automatically raise their temperature up to the set temperature,
and then the machine starts printing.
• When the set value has been set to "NONE", the heaters do not lower
their temperature to the preheat one.
OFF TIME
The heaters are turned off in the following cases:
• When printing is not performed longer than the preset time in the standby
mode
• When printing is not performed longer than the preset time after printing
has been completed with "NONE" being selected for the set value of
"STANDBY"
Set Value:NONE, 0 to 90 min (by the unit of 10 min)
If the machine receives data with the heaters turned off, the heaters are
automatically turned on to raise their temperatures up to the preset levels
and then the machine starts printing.
• When "NONE" is selected for the set value, the heaters are not turned off.
• When "0 min" is set for the set value, the heaters are turned off after
printing has been complete.
To Next Page
Loading...
