If the Positions of Dots Shift...
3-7
1
1
3
Convenient use
5
6
8
Press to correct the dot position of Pattern
1.
• Corrected feeding rate: -40 to 40
• Check the test patterns. The position where an outward feeding
line and a return feeding line become one straight line is the
correction value.
• When the correction value in not between -40 and 40, adjust the
height of the printing heads and then perform the operations in
Step 2 and later.
• 2 types of the correction value is available depending on the head
height.
9
Press the key.
10
In the same way as in Step 4, correct the dot position in Pattern 2 and subsequent
patterns and press the key.
11
Press the key several times to end the setting.
To Next Page
Loading...
