MIMAKI JV34-260 - Head Height Adjustment Lever Details

Setting a Media
2-7
1
2
Basic Operations
4
5
6
5
Fix the carriage while holding the height-adjusting
lever.
• By moving the lever of the right side of the carriage
downward and fastening the screw in front, you can fix the
carriage.
• Be sure to fix the carriage while holding the height-adjusting
lever. Otherwise, you cannot fix the head at the proper
position.
• Fasten the screw securely.
6
Return the carriage to the station position.
For the Adjusting Lever and the Range
Range
Height-adjusting
lever
Head height Switching area
L range
(General printing)
Thin
2mm
(The set position at
shipping)
Switch by user
Contact our sales office
for switching
L  H by field person.
Thick 3mm
H range
(Transfer type printing)
Thin 3mm
Thick 4mm
• Set the lever to "Thick" when a thicker media such as tarpaulin or FF is used.
• Set the lever to "Thick" when the media is prone to gather dust in the head or is often stained with ink
traces.
• If solvent ink is selected, do not use with H range. It adversely affects the image quality.
• When using the media of 1mm thickness or below and SS21 ink, be sure to set the head height to
"Thin".
If using with the head height "Thick", as the head gap (between the media and the height of head
nozzle surface) can be too large and ink drops may be splashed, the image quality cannot be
assured.
While holding the
lever, fix the carriage.