MIMAKI JV34-260 - Page 57

Setting a Media
2-29
1
2
Basic Operations
4
5
6
4
Press to determine the origin of the width direction.
5
After determining the origin, press the key.
• The origin is changed.
Typical setting position of printing origin
The printing origin in the depth direction (X') is positioned at about 75 mm rearward from the slot for cutting on
the platen. The printing origin in the scanning direction (Y') is positioned at 25 mm from the right end of the
media. The value in the scanning direction (Y') can be changed using [MARGIN] in FUNCTION mode.
( P.3-3) This can be changed by using the Jog key.
OR I G I N SE T UP
** ORIGIN **
slot for cutting
approx. 75 mm
(X’)
25 mm
(Y’)