MIMAKI JV34-260 - Page 121

Printing on Double Side
4-9
1
1
4
Double Sided Printing
6
11
Press to set the number of
ink layers (1 to 9).
• Set the number of ink layer for printing on the back side.
12
Press the key.
13
Press tonselect [MEDIA DETECT].
14
Press the key.
• The setting “MEDIA DETECT” is selected.
15
Press to set the detection interval
(OFF/ 10 to 10000 mm).
• Set the interval to check the media misalignment.
16
Press the key.
17
Press the key several times to end.
• While printing on the back side of translucent media, the printer follows the setting below.
The settings on [SETUP] function or on Raster Link Pro are invalid.
Doub l eS i de Mode
INK LAYERS :4
Doub l eS i de Mode
Pr intOfBackSide<ent>
Doub l eS i de Mode
MED I A DE T EC T < e n t >
Doub l eS i de Mode
De t ec t I NTVL :OFF
Doub l eS i de Mode
De t ec t I NTVL : 1000 mm