Printing on Double Side
4-11
1
1
4
Double Sided Printing
6
3
Set the media so that the cuts on the cutting line become parallel to the line of the
platen.
• Set on the platen line, whichever is easier to check.
4
Push down the clamp lever
.
• Media detection starts.
• When media detection is completed, media type selection screen appears.
5
Select the media type (translucent or opaque media).
• After selecting media type, set position check line is automatically
printed, and the lines are fed up to the LED light unit (option).
6
Check the media is set parallel.
• Check the media is set parallel with the print on the
front side.
7
If the media is set parallel, press the key.
• If the media is not set parallel, raise the clamp lever and follow from the Step 3 again.
• The set position check line can be printed up to six times. When setting the media again, check the
newly printed lines are parallel to the front side.
• When using the take-up device, check the lines are parallel, and set the media on the take-up device.
8
Start Raster Link Pro 5, and select an image to print.
• For details about image selection, see Reference Guide (Common features for every printer) of Raster
Link Pro 5.
To Next Page
Loading...
