5-6
4
Clean the wiper and bracket.
• Wipe off the ink sticking to the wiper and bracket with a
clean stick dipped in cleaning solution for maintenance.
5
Clean the wiper slider.
• Wipe off the ink sticking to the wiper slider with a clean stick
dipped in cleaning solution for maintenance.
6
Set the wiper at the original position.
• Insert the wiper by holding both ends of the wiper.
7
Clean the cap rubber and wiper cover.
• Wipe off the ink sticking to the cap rubber and wiper cover
with a clean stick dipped in cleaning solution for
maintenance.
8
Close the front cover then press the key.
• After its initial operation, the machine returns to LOCAL.
Performing the station maintenance without key
You can select station maintenance by using the key in the Local without pressing the
key.
Press the
key in Local.
Press to
select [MAINTENANCE].
Press the key twice.
• It becomes the same condition as the
key is pressed from Local.
To Next Page
Loading...
