MIMAKI JV34-260 - Page 154

5-28
Confirmation Message in LOCAL
The message on the right is displayed.
1
Check the state of the waste ink tank and replace it with another as necessary.
(P.5-29)
When You Do Not Want the Confirmation Message of the Waste Ink Tank to Be Displayed
You can configure the setting so that the confirmation message of the waste ink tank is not displayed.
1
Select [Waste Ink Warning] of the machine setup menu.
(1) Press the key in LOCAL.
(2) Press to select [MACHINE SETUP] and press the key.
(3) Press to select [Waste Ink Warning].
(4) Press the key.
2
Press to select OFF.
3
Press the key.
4
Press the key several times to end the setting.
• When you set Waste ink warning to "OFF", the confirmation message is not displayed.Make sure to
visually check the amount of ink remaining in the waste ink tank.
<LOCAL . 1> [ #01 ]
!WASTE TANK
Wa s t e I n k Wa r n i n g
SETUP :
OFF
MACH I NE S E TUP
Wa s t e I n k Wa r n i n g < e n t >