MIMAKI JV34-260 - Loading Heavy-Duty Roll Media onto Shaft; Attaching and Securing Roll Media

2-10
3
Remove the heavy-duty roll holders.
• The heavy-duty roll holders are on both sides of the shaft.
Remove them with the following procedures.
(1) Loosen the screws with the supplied hexagonal wrench.
(2) Remove the heavy-duty roll holders.
l
4
Attach the paper core.
(1) Put the roll shaft through a paper core.
(2) Slide the paper core to the center of the roll shaft.
(3) Push the heavy-dury roll holders on both sides into the
paper core.
(4) Tap the heavy-duty roll holders with the supplied
hammer to push into the paper core.
5
Set the roll shaft with the paper core on the heavy-duty take-up device, and close the
covers on both sides of the roll shaft.
Hexagonal
wrench
Heavy-
duty roll
Paper core
Hammer