10 - 6 Operator’s Manual
10 Patient Data Management
– Tap [Restore Items] to restore the item to iStation.
– Tap [Delete] to delete the item permanently. The item can never be restored again.
2. Tap [Done] to exit the screen.
To set maximum number of days for deleted data to be kept in the recycle bin
The patient exams which exceed the preset maximum will be deleted and unrecoverable, it is
recommended to perform patient data backup before enabling this function to avoid data loss.
Perform the following procedure:
1. Input the desired number besides “Maximum number of days to be kept”.
If the input box is left blank, the feature will not be enabled.
Only the whole number ranging from 1 to 365 can be input.
2. Tap [Modify].
10.5 iStorage
Network storage is used to save image files and measurement reports to the remote PC server.
For network storage setting, see the Setup chapter.
Perform the following procedure:
1. Enter iStation, select one (or more than one) patient data or image in the local data source.
2. Tap [Send To].
3. Select [iStorage] in the Send To dialog box, and select the PC server of the right side.
4. Select PC transfer format and check whether to send report.
5. Tap [Send] to start sending.
10.6 Print
For printer connection, see the System Preparation chapter.
For details about printer selection and print service setting, see the Setup chapter.
10.6.1 Image Printing
For DICOM image printing, refer to relevant chapters. Video printer is applied in image print
service.
Print current screen image
In the main screen, use [Freeze] to freeze the image and tap [Print] to print the current screen
image.
Image print via send to function
Perform the following procedure:
1. Select the desired image in the iStation or Review screen.
2. Tap [Send To] and select the printer in the dialog box which appears.
3. Tap [Send] to start printing.
To Next Page
Loading...
Need help?
General