Mindray TE9 - Storage and Transportation

12 Probes and Biopsy
Operator’s Manual 12 - 19
12.1.9 Storage and Transportation
When all examinations for the day have been completed, confirm that the probe is in good
condition. After disinfecting the probe, confirm that the probe is in good condition and stored in a
suitable place
• To prevent the probe from being damaged, DO NOT store it in locations where it may be
exposed to:
– Direct sunlight or X-rays
– Sudden changes in temperature
–Dust
– Excessive vibration
– Heat generators
• When the probe is sent to MINDRAY Customer Service Department or sales representative for
repair, be sure to disinfect it and keep it in the carrying case to prevent infection.
LAP13-
4Cs
Operating 0°C ~ 40°C 20% ~ 85% 700 hPa ~ 1060 hPa
Storage and
transportation
-20°C ~ 55°C 20% ~ 95% 700 hPa ~ 1060 hPa
L14-5sp Operating 10°C ~ 40°C 30% ~ 85% 700 hPa ~ 1060 hPa
Storage and
transportation
0°C ~ 60°C 30% ~ 95% 700 hPa ~ 1060 hPa
L7-3s Operating 0℃~40℃ 30%~85% 700 hPa ~ 1060 hPa
Storage and
transportation
-20℃~55℃ 30%~95% 700 hPa ~ 1060 hPa
L14-6s Operating 0℃~40℃ 30%~85% 700 hPa ~ 1060 hPa
Storage and
transportation
-20℃~55℃ 30%~95% 700 hPa ~ 1060 hPa
6CV1s Operating 0℃~40℃ 25%~90% 550 hPa ~ 1060 hPa
Storage and
transportation
-20℃~55℃ 10%~95% 500 hPa ~ 1060 hPa
7L4s Operating 0℃~40℃ 30%~85% 700 hPa ~ 1060 hPa
Storage and
transportation
-20℃~55℃ 30%~95% 700 hPa ~ 1060 hPa
L14-5Ws Operating 0℃~40℃ 20%~85% 700 hPa ~ 1060 hPa
Storage and
transportation
-20℃~55℃ 20%~95% 700 hPa ~ 1060 hPa
C9-3Ts Operating 0℃~40℃ 20%~85% 700 hPa ~ 1060 hPa
Storage and
transportation
-20℃~55℃ 20%~95% 700 hPa ~ 1060 hPa
Table 12-3 Probe Environmental Conditions
Probe
Model
Conditions Ambient
temperature
Relative humidity
(no condensation)
Atmospheric
pressure