1 - 4 Operator’s Manual
1 Important Information
• Except accessories that have been stated as sterile, the system and its
accessories are not disinfected or sterilized prior to delivery. The operator
is responsible for the cleaning and disinfection of probes and sterilization of
biopsy brackets according to the manuals, prior to the use. All items must
be thoroughly processed to completely remove harmful residual chemicals,
which will not only harmful to the human body, but also damage the
accessory.
• It is necessary to end the current scan that is in progress and clear the
current Patient Information field. Otherwise, new patient data may be
combined with the previous patient data.
• Do not connect or disconnect the system’s power cord or its accessories
(e.g., a printer or a recorder) without turning OFF the system power first.
This may damage the system and its accessories or cause electric shock.
• If the system is powered off improperly during operation, it may result in
data damage of the system’s hard disk or system failure.
• Do not use a USB memory device (e.g., a USB flash drive, removable hard
disk) which has unsafe data. Otherwise, system damage may result.
• It is recommended to only use the video devices specified in this manual.
• Do not use gel, disinfectant, probes, probe sheath or needle-guided
brackets that are not compatible with the system.
• The applied contrast agency should be compliant with the relevant local
regulations.
• Read the Acoustic Output Principle in the operation manual carefully before
operating this system on clinical examination.
• The cover contains natural rubber that can cause allergic reactions in some
individuals.
• Please use the ultrasound gel compliant with the relevant local regulations.
• DO NOT expose the system to excessive vibration through transportation.
Mechanical damage may result.
• Always keep the system dry. Avoid transporting this system quickly from a
cold place to a warm place; otherwise condensation or water droplets may
form allowing a short circuit and possible electric shock.
• DO NOT use the system in the vicinity of strong electromagnetic field (such as a transformer),
which may affect the performance of the system.
• Do not use the system in the vicinity of high-frequency radiation source (e.g. cellular phones),
which may affect the performance of the system or even lead to failure.
• When using or placing the system, keep the system horizontal to avoid imbalance.
• To avoid damaging the system, do not use it in following environment:
– Locations exposed to direct sunlight.
– Locations subject to sudden changes in environmental temperature.
– Dusty locations.
– Locations subject to vibration.
To Next Page
Loading...