4 - 14 Operator’s Manual
4 Setup
b. Tap [Wipe] or [Security Wipe] and operate according to the screen prompts to clear
patient data.
c. Select [User Define] again, and tap [Confirm].
d. Input the password and tap [Confirm] to finish the password setting.
• If you want to switch to Factory Default, perform steps above again. The password is the same
as that of the User Define.
• When you set password, multi-language and Chinese characters are not supported.
• [Security Wipe] has a higher security level but takes longer time than [Wipe].
Anti-Virus
The system provides two anti-virus software: Windows Defender and McAfee. They can
effectively prevent the ultrasound system from being attacked by virus, spyware, or other malware.
If the McAfee software is installed, the system displays “McAfee is running”; if not, the system
displays “McAfee is not installed”. The McAfee software is an option. If you want to buy McAfee,
contact the service engineer.
• McAfee cannot be uninstalled after successful installation.
• McAfee can also be installed after installation of Windows Defender.
• If McAfee is improperly installed due to power-off, shut-down, closing of cmd.exe, or any
other abnormal operation during the installation, please contact the service engineer.
Transmission Encryption
After accessing the network, tap [VPN Config] to enter the “VPN Config” interface.
Item Description
Status No driver: tap [Setup Driver] to enter the "TAP-Windows 9.21.2 Setup"
interface, and do as instructed.
• Ready: the VPN is ready for use.
• Advance: VPN Advance Configuration
• Connected: VPN is successfully connected.
• Disconnected: VPN is disconnected.
• Error: error connection.
Server IP /
Group
User Name
Password
Hide characters The password is displayed as *.
Connect/ Disconnect Connect or disconnect VPN.
To Next Page
Loading...
Need help?
General