③ Selection of writing or reading out (R/W)
Writing or reading out is selected by the command order.
Writing the data set in General data area (RWwnC ~ RWwnD) is ordered for writing by
command No. (RWwnE)
Reading out the data set in General data area (RWwnC ~ RWrnD) is ordered for reading
out by command No. (RWwnE).
ON ：Reading out
OFF ：Writing
④ Operation mode changeover request (Request 3)
Writing of the data set in operation mode (RWwnF) is requested.
This function is prepared for future expansion, and CSD-892-73 is not equipped with.
ON ：In the request of changeover.
OFF ：After confirming [Operation mode changeover response (Response 3)
⑤ ZERO
ZERO set is executed.
ON ：In requesting the execution of ZERO set (Operated once by OFF → ON)
OFF ：Normal
⑥ ZERO clear
ZERO clear is executed.
ON ：In req
uesting the execution of ZERO clear (Operated once by OFF → ON)
OFF ：Normal
⑦ Tare weight cancellation
Tare weight cancellation clear is executed.
ON ：In requesting the execution of tare weight cancellation
(Operated once by OFF → ON)
OFF ：Normal
⑧ Tare weight cancellation clear
ON ：In requesting the execution of tare weight cancellation clear
(Operated once by OFF → ON)
OFF ：Normal
⑨ HOLD
The holding target selected from [Display], [Comparison result] or [Gross/Net value of CC-
Link interface] by the setting of function F-18 is held.
ON ：HOLD (Level operation)
OFF ：HOLD OFF
93
CC-Link
To Next Page