1 stations occupied (Master → CSD-892-73)
Device No. Contents Classification
RYn0 ⑤ ZERO
Control signal
RYn1 ⑥ ZERO Clear
RYn2 ⑦ Tare weight cancellation
RYn3 ⑧ Tare weight cancellation clear
RYn4 ⑨ Hold
RYn5
RYn6
RYn7 ⑮ Indicate value changeover flag (Net value/Gross value)
RYn8
RYn9
RYnA
RYnB
RYnC
RYnD
RYnE
RYnF
RY(n+1)0
System reservation zone
RY(n+1)1
RY(n+1)2
RY(n+1)3
RY(n+1)4
RY(n+1)5
RY(n+1)6
RY(n+1)7
RY(n+1)8
RY(n+1)9 ⑬ Initialed data
setting request flag
RY(n+1)A ⑭ Error reset requesting flag
RY(n+1)B
RY(n+1)C
RY(n+1)D
RY(n+1)E
RY(n+1)F
n : Value decided by setting of station No.
* Error reset is operated by main body side because error cancellation request flag is not
defined in 1 occupied station. (Synchronize with reset of the main body.)
① Setting value writing request (Request 1)
Writing of the data set in special data area (RWwn0 ~ RWwnB) is requested
ON ：In the request of writing
OFF ：After confirming [Setting value writing response (Response 1)]
② General command request (Request 2)
Writing or reading out is requested by the command order.
Use with selection of writing or reading out (R/W) at the same time.
ON ：In the request of writing/reading out
OFF ：After confirming [Setting value writing response (Response 2)]
92
CC-Link
To Next Page