I-17 Di251/Di351Rev. 11..0.0/03.01
right
1.5.2 Shift Tray Installation
1. Remove the panel from the front side of the
copier.
2. Remove the rear paper exit cover (1 screw)
and free the harness that is attached to the
backside of the cover.
NOTE
Make sure that the harness does not fall inside
the copier.
3. Cut off the treaded tires from the Exit Rolls of
the machine.
4. Use three screws (4 ¥ 8 mm) to secure the
rear end of the mounting frames (front/rear)
from the front side of the copier as shown.
NOTE
Install the mounting frame so the pins pass
through the holes at the rear side of the copier.
To Next Page
Loading...
