Minolta Di251 - Installation Ad-15; Unpacking; Automatic Duplex Unit Setting-Up

To Next Page

To Previous Page

I-20Di251/Di351 Rev. 1.1.0.0/03.01

left

1.6 INSTALLATION AD-15

1.6.1 Unpacking

1. Remove the automatic duplex unit from the packing box. Remove the plastic

bag, tape and the label that indicates not to raise the unit.

2. Verify the packing contents.

1. Automatic duplex unit....................................... 1

2. Unpacking and setting-up instructions............. 1

1.6.2 Automatic Duplex Unit Setting-up

1. Turn off the power and disconnect the power

cord and interface cable from the copier.

Open the manual feed table.

2. Remove the Duct Cover. (for Di251 only)

3. Peel off the polyester film as shown.

UNPACKING/SETTING-UP

INSTRUCTIONS

Other manuals for Minolta Di251