Minolta Di251 - Adjusting the Position of the Rear Guide Plate; Checking and Adjusting the Position of the Guide Plate in the Single Feed Copy Mode; Checking the Position of the Rear Guide Plate

I-46Di251/Di351 Rev. 1.1.0.0/03.01
left
1.8.13 Checking the Position of the Rear Guide Plate
Check the paper to see how many mm its rear
edge deviates in the “A” or “B” direction with
reference to a line 4.0 mm to the front of the end
face of the FD Scale.
Allowable deviation : 4.0 ± 1.0 mm
1.8.14 Adjusting the Position of the Rear Guide Plate
Move the Rear Guide Plate to the front or back as
necessary to meet the above requirements.
Less than 3.0 mm : To the front
More than 5.0 mm : To the back
1.8.15 Checking and adjusting the position of the guide plate in the single
feed copy mode
1. Set the copier into the following mode:
Auto Paper Select
One-sided Original One-sided Copy
2. Insert a sheet of A4 or Letter size paper
crosswise into the Single Feed Tray along the
Rear Paper Guide.
3. When the paper feeds automatically and the
scanning starts, open the paper guide
F1 immediately.
4. After the paper is fed onto the Original Glass,
open the Duplexing Document Feeder gently.
NOTE
When the Duplexing Document Feeder is
opened quickly, the paper will be knocked out of
position.
A
B
4±1mm