Minolta Di251 - Adjusting the Hole-Punching Positions (FN-109 Only); Removing the Rail

I-58Di251/Di351 Rev. 1.1.0.0/03.01
left
1.9.9 Adjusting the Hole-Punching Positions (FN-109 only)
1. Open the upper cover, and then loosen the
hole-punching guide securing screw.
Move the green slider to adjust the hole-
punching position.
2. Tighten the securing screw.
3. Close the upper cover.
4. Make another test print, and then check that
the punched holes are aligned.
NOTE
If the punched holes are not at their standard
positions, adjust the hole-punching position.
1.9.10 Removing the Rail
1. Pinch together the rail stoppers on the left
side of the finisher to release them.
2. Disconnect the two hookup cords.
3. Remove the horizontal transport unit from the
finisher, and then place it on top of the copier.
4. Carefully pull the finisher away from the
copier.
5. Slide the rail under the copier, and then
remove it from the right side of the copier.