Minolta Di251 - How to Remove the Pipe; Installing the Transport Unit

I-62Di251/Di351 Rev. 1.1.0.0/03.01
left
1.10.4 How to remove the pipe
Releasethe pipe by squeezing the stopperthat is
located on the left side of the Finisher. Gently
push the Finisher to the left. Repeat the
procedure to release the stopper on the other
side of the main unit and remove the pipe from
themainunit.
1.10.5 Installing the transport unit
1. Cut off the treaded tires from the Exit Rolls of
the machine.
2. Install the feeder attachment of the transport
unit onto the main unit.
NOTE
Be sure to align the pins (2) located on the bottom
of the feeder attachment with the holes (2) of the
main unit during installation.
3. Mount the horizontal transport unit on the exit
section of the copier.
4. Open the coverof the horizontaltransport unit
and fit the shaft of the horizontal transport unit
positively into position as illustrated.
Stopper
1
2
Lock lever