Minolta Di251 - Attaching the Finisher Set Pin; Attaching the Pipe

I-61 Di251/Di351Rev. 11..0.0/03.01
right
1.10.2 Attaching the Finisher set pin
Using the thumbscrews (3), attach the Finisher
set pin and the magnetic fitting to the left side of
the copier as shown in the diagram.
1.10.3 Attaching the pipe
1. Attach the black guide-rail molding to the
copier as shown in the diagram.
NOTE
The black guide-rail molding will click into place
when properly installed.
2. Insert one end of the pipe into the insertion
guide that is attached to the side of the Tray.
NOTE
The black guide-rail molding will click into place
when properly installed.
3. Set the finisher with the main unit by inserting
one end of the pipe that was used in STEP 2
into the side of the main unit where the feeder
attachment is installed.