Minolta Di251 - Installation Afr-17; Unpacking; Installing

I-35 Di251/Di351Rev. 11..0.0/03.01
right
1.8 INSTALLATION AFR-17
1.8.1 Unpacking
Open the carton and take out the following accessories.
1. Exit tray.................................................4
2. Shoulder Head Screw...........................4
3. Screw....................................................1
1.8.2 Installing
1. Remove the Rear Cover (two screws) of the
copier.
2. Tighten the two Shoulder Screws that come
with the document feeder into the holes in the
rear.
3. Lift the Duplexing Document Feeder up and
set it onto the copier so that the screws
mentioned above fit into the holes of both
hinges.
NOTE
When mounting the Duplexing Document
Feeder, be careful to hold it by the top andbottom
sides.
1
2
3