FrameMaker Ver.5.5(PC) Di251/Di351 TROUBLESHOOTING
05.03.01
T- 4 7
5. IMAGE FAILURE
5-1. Image Failure Troubleshooting
• If any image failure has occurred, first make the initial checks, then proceed to the corre-
sponding image failure troubleshooting procedure.
5-2. Initial Checks
• Determineifthefailureisattributabletoabasiccauseorcauses.
• Determine if the failure is attributable to an input system (IR) or output system (engine)
fault.
Section Step Check Result Action
Installation
site
1 “PRECAUTIONS FOR
INSTALLATION” contained in
GENERAL
NO Change the installation site.
Paper 2 Recommended paper is used. NO Instruct user.
3 Paper is damp. YES Change paper.
Instruct user in paper storage.
Original 4 Original not flat YES Correct.
5 Faint original YES Instruct user.
6 Highly transparent original
(OHP transparencies, etc.)
YES Instruct user.
7 Dirty or scratched Original
Glass
YES Clean or change.
PM parts 8 PM parts relating to image for-
mation have reached the end
of cleaning/replacement
cycles.
YES Clean or change.
(See Maintenance Schedule.)
Adjust-
ment items
9 There are adjustment items
that remedy the image failure
when readjusted.
YES Readjust.
Check Result Cause
Make copies at different
zoom ratios.
Input
system
Output
system
1177T03YA
1177T04YA
1177T05YA
To Next Page
Loading...
