Minolta Di251 - Safety Precautions for Inspection and Service

FrameMaker Ver.5.5E(PC) PL/PS Standard Document Ver.01
05.03.01
P-1
Safety Precautions for Inspection and Service
When performing inspection and service procedures, observe the following precautions to
prevent accidents and ensure utmost safety.
✽ Depending on the model, some of the precautions given in the following do not apply.
1. Always observe precautions.
2. Before starting the procedures, be sure to unplug the power cord.
3. Use the specified parts.
4. Handle the power cord with care and never use a multiple outlet.
5. Be careful with the high-voltage parts.
6. Do not work with wet hands.
WARNING
• Parts requiring special attention in this product will include a label containing the
mark shown on the left plus precautionary notes. Be sure to observe the precau-
tions.
• Be sure to observe the “Safety Information” given in the Operator’s Manual.
• This product contains a high-voltage unit and a circuit with a large current
capacity that may cause an electric shock or burn.
• The product also contains parts that can jerk suddenly and cause injury.
• If this product uses a laser, laser beam leakage may cause eye damage or
blindness.
• For replacement parts, always use the genuine parts specified in the manufac-
turer’s parts manual. Installing a wrong or unauthorized part could cause dielec-
tric breakdown, overload, or undermine safety devices resulting in possible
electric shock or fire.
• Replace a blown electrical fuse or thermal fuse with its corresponding genuine
part specified in the manufacturer’s parts manual. Installing a fuse of a different
makeorratingcouldleadtoapossiblefire.Ifathermalfuseblowsfrequently,
the temperature control system may have a problem and action must be taken
to eliminate the cause of the problem.
• Do not break, crush or otherwise damage the power cord. Placing a heavy
object on the power cord, or pulling or bending it may damage it, resulting in a
possible fire or electric shock.
• Do not use a multiple outlet to which any other appliance or machine is con-
nected.
• Be sure the power outlet meets or exceeds the specified capacity.
• A part marked with the symbol shown on the left carries a high voltage. Touch-
ingitcouldresultinanelectricshockorburn.Besuretounplugthepowercord
before servicing this part or the parts near it.
• Do not unplug or plug in the power cord, or perform any kind of service or
inspection with wet hands. Doing so could result in an electric shock.