Minolta Di251 - Adjusting the Adjusters; Attaching the Paper Feed Unit to the Copy Table

I-7 Di251/Di351Rev. 11..0.0/03.01
right
1.2.4 Adjusting the Adjusters
With the wrench (1031-7809-01), adjust the
height of the adjusters (front and back) to
stabilize the unit on the floor.
The wrench is not enclosed.
Caution
Be sure to set the adjusters as specified. Failure
to set the adjusters correctly may cause the unit
tobecome unbalancedand fall,possibly resulting
in serious injuries.
1.2.5 Attaching the paper feed unit to the copy table
1. Place the paper feed unit on top of the copy
table so that the rubber feet on the paperfeed
unit are correctly aligned on the copy table.