Minolta Di251 - Checking for Zoom Adjust

I-30Di251/Di351 Rev. 1.1.0.0/03.01
left
9. Install the Tray.
1.7.5 Checking for Zoom Adjust
1. Prepare a test chart (A3) as shown.
Drawa 200-mm-longstraight reference linein
the crosswise direction (A: CD).
Drawa 300-mm-longstraight reference linein
the feeding direction (B: FD).
2. Load the test chart in the ADF and make a
full-size copy.
3. Check that the lengths of the reference lines
reproduced on the copy, A (CD) and B (FD),
meet the following specifications.
Reference Line Registration Specifications:
A (CD): 200 ± 2.0 mm
B (FD): 300 ± 4.5 mm
If the length of the line reproduced on the
copy falls outside the specified range, make
the “Registration Adjustment.”
300mm
200mm