Minolta Di251 - Paper Take-Up;Transport Misfeed (2 Nd Fixed Paper Size Cassette

FrameMaker Ver.5.5(PC) Di251/Di351 TROUBLESHOOTING
05.03.01
T- 2 1
Paper Take-Up/Transport Misfeed (2nd Fixed Paper Size Cassette/PF-118/PF-119) Trou-
bleshooting Procedures
• Paperisnottakenupatall.
Step Check Result Action
1 Paper meets product specifications. NO Change paper.
2 Paper is curled, wavy, or damp. YES Change paper.
Instruct user in correct
paper storage.
3 Edge Guide and Trailing Edge Stop are at cor-
rect position to accommodate paper.
NO Set as necessary.
4 Paper Take-Up Roll is dirty, deformed, or worn. YES Clean or change.
5 Mylar is dirty or deformed. YES Clean or change.
6 Paper Lifting Plate is dirty or deformed. YES Clean or change.
7 Paper Separator Roll is dirty, deformed, or
worn.
YES Clean or change.
8 Paper take-up guide plate is dirty or deformed. YES Clean or change.
9 The voltage across PJ6A-1 on Control Board
and GND is DC24 V.
YES Check step 11 and
onward.
10 Fuse is conducting. YES Change Power Supply
Unit.
NO Change fuse.
11 Paper Take-Up Motor drive check: Vertical
Transport Roller turn when the Power Switch is
turned ON.
NO Change Paper Take-Up
Motor.
Change Control Board.
Change Master Board.
12 Paper Take-Up Clutch operation check: the
voltage across PJ3A-14B on Control Board
and GND changes from DC24 V to DC0 V
when the Start key is pressed.
YES Change Paper Take-Up
Clutch.
NO Change Control Board.
Change Master Board.