Minolta Di251 - Installing the Copy Table;Copy Desk

I-6Di251/Di351 Rev. 1.1.0.0/03.01
left
1.2.3 Installing the Copy Table/Copy Desk
NOTE
Be sure to attach the stabilizers; otherwise, the
unit may become unbalanced and fall over,
causing injuries.
1. Attach the three grounding plates (two inside
and one at the right-front corner) to the copy
table/copy desk at the positions shown in the
illustrations at the left (using a grounding
plate screw for each plate).
2. Using one screw for each stabilizers, attach the two stabilizers A and stabilizer
B to the copy table or copy desk at the positions shown in the illustration below.
3. Attach the two adjusters to the copy table or copy desk at the positions shown
in the illustration at the left.
Stabilizers A
Adjusters
Stabilizer B