Minolta Di251 - Adjusting the Height and Tilt of the Finisher

I-54Di251/Di351 Rev. 1.1.0.0/03.01
left
1.9.4 Adjusting the Height and Tilt of the Finisher
1. If the finisher gradually tilts toward the copier,
check the following:
Are the stabilizing pin and the hole in the
finisher at the same height?
Is the horizontal transport unit not extremely
tilted?
If the finisher is not at the same height as the
copier, adjust the copier as follows.
2. Slide the finisher away from the copier, and
then remove the lower-front cover (two
screws) of the finisher.
3. Lift the finisher’s two caster covers up, and
then pull them off.
4. Without turning the adjusting bolt (lower bolt)
on the caster, loosen the securing bolt (upper
bolt), and then turn the adjusting bolt (lower
bolt) as indicated below to adjust the height of
the finisher.
Two rear casters
If the stabilizing pin is too high:
Turn the bolt clockwise
If the stabilizing pin is too low:
Turn the bolt counterclockwise
Two front casters
If the magnet is too high:
Turn the bolt clockwise
If the magnet is too low:
Turn the bolt counterclockwise
Securing bolt
Adjusting bolt