Minolta Di251 - Paper Size Input for the Fixed Cassette

I-85 Di251/Di351Rev. 11..0.0/03.01
right
5. Move the edge guides to the desired paper
size and secure them.
After reinstalling the edge guides, recheck
the markings in the bottom of the tray to make
sure all three guides are set to the desired
paper size.
CAUTION
When installing the edge guides, make sure that
the fingers fitted to the front/rear edge guides are
on top of the paper loaded in the cassette.
6. Load paper and close the drawer.
1.12.7 Paper Size Input for the Fixed Cassette
1. Access the service mode screen.
(Refer to the service manual for the
procedure.)
2. Touch “System Input.”
3. Touch “Paper Size Input.”
4. Select the position where the paper feed unit
is set.
Level History