Minolta Di251 - Drawer Paper Take-Up Control; Paper Take-Up Interval Control; Paper Take-Up Retry Control; Paper Take-Up Roll

FrameMaker Ver5.5E(PC)Di251/Di351 MECHANICAL/ELECTRICAL
05.03.01
M-34
14-7. Drawer Paper Take-Up Control
(1) Paper Take-Up Roll
• Drive from the Main Motor is transmitted via a gear train to the Paper Take-Up Clutch
(spring clutch). The Paper Take-Up Roll is turned when the 1st Drawer Paper Take-Up
Solenoid is then energized.
(2) Paper Take-Up Retry Control
• To minimize the occurrence of a paper misfeed, the paper take-up sequence is tempo-
rarily halted and a paper take-up retry sequence is initiated if the sheet of paper does not
reach the Synchronizing Roller Sensor within a given period of time after the paper take-
up sequence has been started. This sequence is repeated a given number of times.
(3) Paper Take-Up Interval Control
• To minimize the occurrence of a paper misfeed due to improper paper separation, the
interval between two paper take-up sequences is automatically varied according to the
type and size of paper being used.
Electrical Component Control Signal Energized Deenergized Wiring Diagram
SL1 PJ3A-13B L H 5-H
Given No. of Paper Take-Up
Retry Sequences
Paper Take-Up Retry 2
4011M022AA
Main Motor M2
Paper Take-Up Roll
Paper Take-Up Clutch
1st Drawer Paper Take-Up Solenoid SL1