FrameMaker Ver.5.5(PC) Di251/Di351 TROUBLESHOOTING
05.03.01
T- 3 0
Code Description Detection Timing
C0510 Abnormally low fusing
temperature
• The fusing temperature remains 105 °C or less for a
continuous 0.1-sec. period or more during the
standby state or printing.
• The fusing temperature remains a level lower than
the following temperature for a continuous 2-
min
.
period or more during the low-temperature standby
state.
35-cpm copier: 105 °C
25-cpm copier: 80 °C
20-cpm copier (U.S.A. and Canada only): 80 °C
C0520 Abnormally high fusing
temperature
The fusing temperature remains 230 °Cormorefora
continuous 0.1-sec. period or more.
C0650 Faulty Scanner Home
Position Sensor 1
<The Power Switch is turned ON, Original Cover low-
ered, or Start key pressed when the Scanner is at its
home position>
• The Scanner Home Position Sensor 1 is not
unblocked (H) even when the Scanner moves 10
mm to the left.
• The Scanner Home Position Sensor 1 is not blocked
(L) even when the Scanner moves 4 mm to the right
after the Scanner Home Position Sensor 1 has been
unblocked (H).
<The Power Switch is turned ON, Original Cover low-
ered, or Start key pressed when the Scanner is at any
position other than home>
• The Scanner Home Position Sensor 1 is not blocked
(L) even when the Scanner moves 469.5 mm to the
right.
C0651 Faulty Scanner Home
Position Sensor 2
When the Start key is pressed with a document loaded
in the Document Feed Tray of the ADF, Scanner Home
Position Sensor 2 is not blocked (L) even when the
Scanner moves 463 mm to the left after the sensor
has been unblocked (H).
C0990 LCC Lift-Up Motor failure
to turn
See the relevant option service manual.
C0991 Lift 1 ascent motion fail-
ure
C0995 LCC Transport Motor fail-
uretoturn
C0999 Lift 2 ascent motion fail-
ure
C099D LCC communication
error
C0B00 Transport Motor drive
malfunction
C0B20 Stapling Unit Moving
Motor drive malfunction
C0B30 CD Aligning Motor drive
malfunction
To Next Page
Loading...
