I-51 Di251/Di351Rev. 11..0.0/03.01
right
On the FN-110
NOTE
Be sure to install the finisher on a level surface.
After installing the finisher, do not move the copier unnecessarily.
If it is necessary to move the copier, follow the procedure described under
“Removing the rail” on page I-57.
After moving the copier, perform the operations described in “Installing the
Horizontal Transport Unit” and “Installing the Stabilizing Pin and Rail”.
NOTE: Do not remove these parts.
Packing bracket
Packing bracket
Tape:
To Next Page
Loading...
