(5) Cleaning of the Side Cover
4. Remove one spring and the upper and lower
Synchronizing Roller bushings.
NOTE
• When reinstalling the bushings, make sure that
the flanges of the bushings are on the outside.
4011D015AA
4011D016AC
5. Snap off one retaining ring E type, unplug one
connector, and remove the Synchronizing Clutch.
6. Remove one washer and two wave washers.
7. Unhook one spring, snap off two retaining rings E
type, and remove the upper and lower Synchro-
nizing Roller bushings.
NOTE
• When reinstalling the bushings, make sure that
the flanges of the bushings are on the outside.
4011D017AA
4011D018AB
1. Using a soft cloth dampened with alcohol, wipe
theSideCover.
To Next Page
Loading...
