8. Unplug one connector.
9. Remove five screws and one PWB support. Then, holding the MFB2 Board Assy at the
slit with a finger of your left hand (see the illustration), remove the assy.
NOTES
• When reinstalling the MFB2 Board Assy, push the harness inside the frame to ensure
that it will not interfere with other parts. (Part A of the illustration)
• When reinstalling the MFB2 Board Assy, hook two tabs and press the tab marked with C
up against the mating part. (Parts B and C of the illustration)
• When connecting the connector to the Master Board and fixing the MFB2 Board Assy to
the PWB support as part of the procedure of reinstalling the assy, position the assy as
you look at it from the left-hand side of the assy. (Part D of the illustration)
4011D028AD
4011D105AA
Tab
Tab
B
C
D
A
To Next Page
Loading...
