(2) Removal of the Fusing Roller Heater Lamp, Right Fusing Roller, and Left Fus-
ing Roller
1. Remove the Fusing Unit.
2. Open the Exit Cover.
3. Remove three screws and the Fusing Front
Cover.
NOTE
• After the Fusing Front Cover has been installed,
insert a screwdriver through the hole in the Fusing
Front Cover and move the ends of the flat spring in
the direction of the arrow so that they rest on the
bearing outer race side face.
4011D064AB
WhereFusingFrontCover
is Mounted
WhereEndsofFlatSpring
are Moved
Ends of Flat
Spring
Bearing Outer
Race Side Face
4. Remove one cord holder and the harness.
4011D065AA
5. Remove two screws, six cord holders, and the
harness.
4011D067AA
To Next Page
Loading...
