FrameMaker Ver5.5E(PC) Di251/Di351 MECHANICAL/ELECTRICAL
.05.03.01
M-3
11. Cleaning
• Residual toner is scraped off the surface of the PC Drum.
• The toner is then recycled back to the Developing Unit.
12. Erase
• The PC Drum is exposed to light, which effectively neutralize any residual charge on the
surface of the PC Drum.
13. Fusing
• Heat and pressure applied by the Right and Left Fusing Rollers fuse toner on the paper.
14. Paper Exit
• Feeds paper out of the copier onto the Exit Tray.
To Next Page
Loading...
