FrameMaker Ver.5.5E(PC) Di251/Di351 DIS/REASSEMBLY, ADJUSTMENT
05.03.01
D-51
<FD>
Requirement
• The difference should be within ±1.0 % of the actual length.
• Adjust so that the following specifications are satisfied with a scale length of 300 mm.
NOTE
• This adjustment must be made when the CCD Unit has been replaced and after the
adjustments of Registration (CD and FD) (Printer) have been made.
Adjustment Procedure
Zoom Ratio Specification Adjust Mode Setting Range
Full size (×1.000) 300 ±3.0 mm Zoom Adjust (FD) 0.990 to 1.010
1. Place a scale in parallel with the Original Length
Scaleandmakeacopy.
✽ Use the full size (×1.000) mode and A3 or 11 × 17
paper.
✽ If the scale is of plastic and transparent, place a
blank sheet of paper over it.
1167D112AA
2. Measure the length of the scale on the copy to
find the difference.
Ifthedifferenceisoutsidethespecification,
adjust by following the procedure shown below.
1138D154AA
To Next Page
Loading...
