(9) ROM Version
• Shows the ROM versions.
(10) Level History
• Displays the various level histories.
Touch Panel
Display
Setting (The default is ).
Initial
Transmission
Performs the initial transmission from the PPC to the Center to check
for correct communication after the Data Terminal has been set up.
Counter Clear Clears the spare counter.
<Procedure>
1. Touch the Counter Clear key.
2. Select the number assigned to the counter to be cleared.
Call Completion Transmits the signal of notifying the completion of service job to the
Center.
RAM Clear Initializes the Data Terminal settings.
Common DT Displays the screens for communications settings.
Dial Mode Sets the type of telephone line of the user.
Auto Receive Sets the auto reception function.
Result Code Set the value according to the type of the modem on the copier.
Touch Panel
Display
Setting
ATDC Set Displays the voltage set with ATDC Sensor Automatic Adjustment.
ATDC Current Displays the ATDC Sensor T/C setting in percentage.
Vg Current Displays the current value of the grid voltage.
Vb Current Displays the current value of the developing bias voltage.
Highlighted
YES
NO
Pulse
Tone
YES
NO
To Next Page
Loading...
