FrameMaker Ver.5.5(PC) Di251/Di351 TROUBLESHOOTING
05.03.01
T- 1 5
1st Drawer Take-Up Misfeed Troubleshooting Procedures
• Paperisnottakenupatall.
• Paper is at a stop near the Synchronizing Roller.
Step Check Result Action
1 Paper meets product specifications. NO Change paper.
2 Paper is curled, wavy, or damp. YES Change paper.
Instruct user in correct
paper storage.
3 Edge Guide and Trailing Edge Stop are at cor-
rect position to accommodate paper.
NO Set as necessary.
4 Paper Take-Up Roll is dirty, deformed, or worn. YES Clean or change.
5 Mylar is dirty or deformed. YES Clean or change.
6 Paper Lifting Plate is dirty or deformed. YES Clean or change.
7 Separator Pad is dirty, deformed, or worn. YES Clean or change.
8 Paper take-up guide plate is dirty or deformed. YES Clean or change.
9 1st Drawer Paper Take-Up Solenoid operation
check: the voltage across CN10-1 on the side
of Master Board and GND changes from DC24
V to DC0 V when the Start key is pressed.
YES Change solenoid.
NO Change Master Board.
Step Check Result Action
1 Pre-Image Transfer Guide Plate is dirty or
deformed.
YES Clean or change.
2 Synchronizing Roller Sensor operation check
through I/O check
YES Change Master Board.
NO Check actuator.
Change Synchronizing
Roller Sensor.
To Next Page
Loading...
