Mitel MiVoice Business SMB Controller User Manual

Maintenance
Note:
If the terminal configuration data of system terminals is deleted following the reconfiguration
of a card, a warning message will appear beforehand to give you the possibility of cancelling
the process. However, this is possible only if the configuration data of the original card was
not already deleted beforehand.
11.9.5.3 New Card with More Ports
A card is replaced by a similar card with more ports.
Procedure:
1. Change the card and put the system into operation again. Similar procedure as
described in Replacing a defective interface card.
2.
In the WebAdmin view Cards and modules ( =4g) Confirm the new cards.
3. Configure new ports.
The system configuration data (User No., User configuration, and so on.) of the terminals on the
new ports is created as new data (default values).
11.9.6 System Modules
The category system modules comprises the DSPX2 modules stacked in slot SM1.
The category system modules comprises the modules expandable as an option (DSP modules)
and the mandatory RAM module.
11.9.6.1 Replace DSP Module
The following describes how to replace a DSP module if it is defective or how to replace it for
another module type.
Procedure:
Note:
Be sure to observe the Safety regulations.
Document Version 1.0
System Manual for Mitel SMB Controller 180

Mitel MiVoice Business SMB Controller Specifications

General

Brand	Mitel
Model	MiVoice Business SMB Controller
Category	Controller
Language	English