About SMB Controller
Before you begin with the installation of the SMB Controller:
• Check that the delivery is complete and undamaged. Notify your supplier immediately
of any defects; do not install or put into operation any components that may be
defective.
• Check that you have all the relevant user documents at your disposal.
• Configure this product with only the assemblies specified and, in the locations, stated
in the System Components section of this user documentation.
• During the installation follow the installation instructions for your SMB Controller in the
sequence that is given and observe all the safety warnings they contain.
CAUTION:
Failure to follow all instructions might result in improper equipment operation and/or risk of
electrical shock.
• Install all wiring according to local, state, and federal electrical code requirements.
• Do not connect telecommunications cabling to the system, service the system, or
operate the system with the grounding conductor disconnected.
• Ensure the AC receptacle is installed near the equipment and easily accessible.
• Use only Mitel-approved power adapters.
Any servicing, expansion, or repair work is to be carried out only by trained technical personnel
with the appropriate qualifications.
Opening the SMB Controller - Safety Precautions
Be sure to observe the following safety regulations before carrying out work inside a
communication server:
CAUTION:
Components, interface cards or system modules can be damaged by electrical
voltage. Always shut down, then disconnect the communication server from the
power supply and then wait for 3 minutes before removing the housing cover.
Document Version 1.0
31 System Manual for Mitel SMB Controller
To Next Page
Loading...
Need help?
General
