Revision Date *Manual Number Revision
Feb., 2011 SH(NA)030086ENG-B
Section 3.8.1
Section 3.8.2 (1)
Section 3.8.2 (2)
Section 3.8.2 (3) (a) 1)
Section 3.8.2 (3) (b) 1)
Section 3.8.3 (2)
Section 3.10
Section 3.10.1
Section 3.11.1
Section 3.11.2
Section 3.11.3 (1) to (5)
Section 3.11.4 (1)
Section 3.11.4 (2)
Chapter 4
Section 4.1
Section 4.1.1
Section 4.1.2
Section 4.1.3
Section 4.1.5
Section 4.1.6
Section 4.1.7 (1)
Section 4.1.7 (1) (b)
Section 4.1.7 (2)
Section 4.1.8 (1)
Section 4.1.9
Section 4.1.11
Section 4.1.13
Section 4.1.13 (3)
Section 4.1.13 (4)
Section 4.2.1
Diagram is partially changed.
Note 1 is partially changed.
Note 2 is partially changed.
Note 4 is added.
Partially added.
Partially added.
Note is partially changed.
Note is partially changed.
Partially changed.
Caution is partially changed.
Caution is partially changed.
Caution is partially changed.
Partially changed.
Partially changed.
Partially changed.
Note 3 is partially changed.
Note 4 and Note 5 are added.
Note 4 is partially changed.
Note 5 and Note 6 are added.
Caution is partially added and changed.
POINT is newly added.
Positioning parameters (No. PE
) is added.
POINT is partially added.
Partially changed.
Reference and writing for positioning parameters (No. PE
) are added.
"00Ch" and "10Eh" are added to setting.
"6" and "7" are added to the set value in the first digit.
POINT is partially changed.
Setting item name of each digit is changed.
Note is partially changed.
Note is partially changed.
Partially changed.
Partially changed.
Partially added and changed.
Unit of each control mode is added as Note.
Partially changed.
POINT is partially changed.
Initial value of PA16 is changed from "1" to "0".
Setting range of PA16 is changed from "1 to 65535" to "0 to
65535".
Partially changed.
Partially changed.
Initial values and units of the following parameters
are changed.
PB06
Initial value "70" to "7.0"
Unit "
0.1" to "Multiplier"
PB10
Initial value "337" to "33.7"
Unit "
0.1ms" to "ms"
To Next Page
Loading...
