Mitsubishi Electric MELSERVO-JN Series - Page 468

Revision Date *Manual Number Revision
Feb., 2011 SH(NA)030086ENG-B
Section 4.2.1
Section 4.2.2
PB19
Initial value "1000" to "100.0"
Unit "
0.1Hz" to "Hz"
PB20
Initial value "1000" to "100.0"
Unit "
0.1Hz" to "Hz"
PB27
Unit is changed to "Refer to section 4.2.2.".
PB29
Initial value "70" to "7.0"
Unit "
0.1" to "multiplier"
PB32
Initial value "337" to "33.7"
Unit "
0.1ms" to "ms"
PB33
Initial value "1000" to "100.0"
Unit "
0.1Hz" to "Hz"
PB34
Initial value "1000" to "100.0"
Unit "
0.1Hz" to "Hz"
PB02 Partially changed.
PB06 is changed as follows.
Initial value "70" to "7.0"
Setting range "0 to 3000" to "0.0 to 300.0"
Unit "
0.1" to "multiplier"
PB10 is changed as follows.
Initial value "337" to "33.7"
Setting range "1 to 10000" to "1.0 to 1000.0"
Unit "
0.1ms" to "ms"
PB12 The following sentence is added to the end.
"Executing one-touch tuning automatically changes this
parameter."
PB15 The following sentence is added to the end.
"Executing one-touch tuning automatically changes this
parameter."
PB16 The following sentence is added to the end.
"Executing one-touch tuning automatically changes this
parameter."
PB19 is changed as follows.
Initial value "1000" to "100.0"
Setting range "1 to 1000" to "1.0 to 100.0"
Unit "
0.1Hz" to "Hz"
PB20 is changed as follows.
Initial value "1000" to "100.0"
Setting range "1 to 1000" to "1.0 to 100.0"
Unit "
0.1Hz" to "Hz"
PB29 is changed as follows.
Initial value "70" to "7.0"
Setting range "0 to 3000" to "0.0 to 300.0"
Unit "
0.1" to "multiplier"