Mitsubishi Electric MELSERVO-JN Series - Page 469

Revision Date *Manual Number Revision
Feb., 2011 SH(NA)030086ENG-B
Section 4.2.2
Section 4.2.3
Section 4.3.1
Section 4.3.2
Section 4.3.3
Section 4.3.4
Section 4.4
Section 4.4.1
PB32 is changed as follows.
Initial value "337" to "33.7"
Setting range "1 to 50000" to "1.0 to 5000.0"
Unit "
0.1ms" to "ms"
PB33 is changed as follows.
Initial value "1000" to "100.0"
Setting range "1 to 1000" to "1.0 to 100.0"
Unit "
0.1Hz" to "Hz"
PB34 is changed as follows.
Initial value "1000" to "100.0"
Setting range "1 to 1000" to "1.0 to 100.0"
Unit "
0.1Hz" to "Hz"
Partially changed.
Initial values and units of the following parameters are
changed.
PC12
Initial value "0" to "0.0"
Unit "
0.1%" to "%"
PC15
Initial value "30" to "3.0"
Unit "
0.1rev" to "rev"
PC44 "Drive recorder alarm specifying" is newly added.
PC11 is partially changed.
PC12 is changed as follows.
Initial value "0" to "0.0"
Setting range "0 to 1000" to "0.0 to 100.0"
Unit "
0.1%" to "%"
PC13 "Encoder output pulse cycle setting" is added to the
third digit.
PC15 is changed as follows.
Initial value "30" to "3.0"
Setting range "1 to 999" to "0.1 to 99.9"
Unit "
0.1rev" to "rev"
PC22 is partially changed.
PC25 is partially changed.
PC26 is partially changed.
PC27 is partially changed.
PC28 is partially changed.
PC29 is partially changed.
PC44 "Drive recorder alarm specifying" is newly added.
Partially changed.
"Drive recorder function" is newly added.
POINT is partially added.
PD02 "Input signal device selection 0 (CN1-23, CN1-25)" is
newly added.