To Next Page

To Previous Page

WT07627X03

(8) In the [Brightness] section, make the Show/Hide setting for the brightness/darkness status that is detected

by the built-in brightness sensor on the ME remote controller (North America: PAR-U01MEDU, Europe: PAR-

U02MEDA).

Select [Hide] not to display the brightness/darkness icons on the [Floor] or [Block] display.

Select [ ] (yellow) to display the brightness icon when the brightness level in the room reaches the

predetermined brightness level.

Select [ ] (gray) to display the darkness icon when the darkness level in the room reaches the

predetermined darkness level.

Select [

] (yellow/gray) to display the brightness or darkness icon according to the brightness/

darkness level of the room.

Note: If the ME remote controller has no built-in brightness sensor, the brightness/darkness icons will not be displayed on the

[Floor] or [Block] display.

Note: The brightness/darkness detection thresholds are set on the ME remote controller (North America: PAR-U01MEDU,

Europe: PAR-U02MEDA)

[4] Air-conditioner Settings

(1) In the [Test run] section, select [Use] or [Do not use]. Select [Use] when performing a test run from the

operation settings screen, or when editing the electricity meter reading value on the [Measurement] display.

Editing measurement values

1. Touch the “Measurement value edit” button to open the screen below.

Note: The “Measurement value edit” button will appear only when the [Test run] setting is set to [Use].

2. Touch the “Edit the adjusted measurement value” button. Enter the current electricity meter reading value,

and then touch [OK].

Note: Set the setting back to [Do not use] after completing a test run.

Note: The setting will go back to [Do not use] when the time on the AE-200/AE-50 reaches 0: 00 in the morning.

Note: Only the electric energy values on the [Measurement] display will change. This setting will not affect the energy-

control-related screens.

Note: To reset the adjusted measurement value to the original cumulative value, touch the “Edit the offset value” button

and set to “0”.

Measurement value edit

Edit the adjusted

measurement value

Edit the offset value

Mitsubishi AE-200A User Manual

Questions and Answers: