● Mini flat-tip screwdriver
NOTE: The tamper label must be replaced each time the back chassis is removed.
Procedure:
1. Place main seal in back chassis making sure that all tabs fit well in the back
chassis and the seal rests in the groove that goes around the back chassis.
2. Place the battery seal in position in the back chassis.
3. Position the back chassis over the unit.
4. Carefully insert the top of the back chassis under the front housing tab, and move the bottom of the
back chassis to the unit, making sure that the main seal stays located on the back chassis and the
battery seal remains in place and around the battery connector.
5. Verify that the back chassis is positioned correctly, screw holes are aligned to the threads of the front
housing and the external antenna connector is visible through its dedicated hole.
6. Using the Torx driver with the 8IP Torx-Plus bit, screw with a torque of 5.5±0.1 in-lb (0.62±0.011 Nm).
7. Place a new tamper label into its designated slot.
Figure 44: Back Chassis Installation
No. Description
1 Tamper label
5.10.2.9
Installing the Back Cover
Prerequisites: Recommended tools:
68015000841-EL
Chapter 5: Maintenance
116
To Next Page
Loading...
