TX Power Class 4 test
49. Press the corresponding key to proceed to the next test.
Result: The display shows:
The test is
completed.
Press any key
to turn the
radio OFF.
Test is completed. Press any key to turn the radio OFF.
4.12.2
Testing Charger Recognition
Procedure:
1. Turn the radio ON.
2. Connect the Rapid Travel Charger accessory connector to the handset. Check the following:
● LCD display shows charger connected.
● A beep is heard.
● Keypad back-light is turned ON.
● Charging icon is shown.
3. Connect the Vehicle Power Adapter (VPA) Charger accessory connector to the handset. Check the
following:
● LCD display shows charger connected.
● Keypad back-light is turned ON.
4. Connect the handset to the Desktop Charger. Check the following:
● LCD display shows charger connected.
● A beep is heard.
● Keypad back-light is turned ON.
● Charging icon is shown.
5. Connect the handset to the USB Charger. Check the following:
● LCD display shows charger connected.
● Three beeps are heard.
● Keypad back-light is turned ON.
● Charging icon is shown.
6. Connect the handset to the MUC Charger. Check the following:
● LCD display shows charger connected.
● A beep is heard.
● Keypad back-light is turned ON.
● Charging icon is shown.
7. Verify that the battery charger is in progress.
NOTE: The process advance is indicated on the Battery Strength icon.
68015000841-EL
Chapter 4: Test Setup and Testing
63
To Next Page
Loading...
