NEIGHBOUR CELL CHANNEL: 3500
NEIGHBOUR CELL LOCATION AREA: 0017
NEIGHBOUR CELL IDENTIFIER: 01
SLOW RE-SELECT THRESHOLD ABOVE FAST: 10 dB
FAST RE-SELECT THRESHOLD: 10 dB
SLOW RE-SELECT HYSTERESIS: 10 dB
FAST RE-SELECT HYSTERESIS: 10 dB
16. Press CONFIG. Select Call Timers & Trunking.
17. Select Transmission for Trunking Type.
18. Select Continuous for Test Set Transmit Mode.
4.5
Configuring IFR 2968 Setup
Use these procedures to configure the IFR 2968 setup.
Procedure:
1. Turn ON the IFR.
2. Press Systems Mode Key and wait until the digital system is initialized.
3. Press Tetra Mobile → Setup. Enter the System Parameters Screen.
4. Press Channel Plan.
5. Perform one of the following actions:
● For MTP3100/3150/3200/3250 Version A 350–430 MHz radios, press 380+0MS.
The Control Channel automatically changes to 3600, and Traffic Channel automatically changes
to 3700.
● For MTP3100/3150/3200/3250 Version A 806–870 MHz radios, press 380+0MS.
The Control Channel automatically changes to 2040, and Traffic Channel automatically changes
to 2140.
● For MTP3100/3150/3200/3250 Version B and MTP3500/3550 350–470 MHz radios, press Tetra
380+0MS.
The Control Channel automatically changes to 3600, and Traffic Channel automatically changes
to 3700.
● For MTP3100/3150/3200/3250 Version B and MTP3500/3550 806–870 MHz radios, press Tetra
800MS.
The Control Channel automatically changes to 2040, and Traffic Channel automatically changes
to 2140.
6. Press Traffic Channel → Traffic Channel. Check that the marker goes to Timeslot.
7. To change to Timeslot 3, press 3 → Traffic Channel.
8. Press Country Code. Enter 234 and press Country Code.
9. Press Network Code. Enter 2392 and press Network Code.
10. Press Base Color. Enter 1 and press Base Color.
11. Press More.
12. Press Location Area. Enter 22 and press Location Area.
13. Press More.
14. Press Min Rx Level. Enter -110 dBm and press Min Rx Level.
68015000841-EL
Chapter 4: Test Setup and Testing
47
To Next Page
Loading...
